Normative

Standard

Curtains (drapery) Upholstery

German DIN 4102 (B1)

 
Official standard:
Recommended standard:

Principle

A material is classified as B1 if it fulfils the requirements of a B2-test and the ‘fire shaft’ test.

 Ein Material ist klassifiziert nach B1, wenn die Anforderungen enines B2-Tests und der "Brandschachttest" erfüllt sind.

Test method

B2 test

The test specimen is put on a specimen holder that is hung in a test cabinet. A burner flame is applied to it for 15s. The time to reach a marked point is measured. Also the burning droplets are observed by means of a paper placed under the specimen.

‘Fire shaft’ test

A test specimen is hung vertically in a test cabinet with a burner in it. It is subjected simultaneously to a flame for 10min and a constant flow of air from below. The temperature of the smoke and the undamaged length of the specimen are measured.

B2 Test
Das Probestück wird an einem Probenhalter befestigt, der in einem Testgehäuse hängt. Ein Flammenbrenner wird für 15 Sekunden angewandt. Es wird die Zeit gemessen, wann der 'marked point' erreicht ist. Ach die brennenden Tröpfchen werden auf Papier, das sich unter den Testkörper befindet, aufgefangen und beobachtet.

"Brandschachttest"
Ein test, bei dem das Probestück vertikal in einem Testgehäuse mit einem Brenner hängt. Das Probestück wird für die Dauer von 10 Minuten gleichzeitig durch Flammen und einem konstanten Luftstrom von unten beansprucht. Die Rauchtemperatur und die Restlänge des Probestücks werden gemessen.  

Result

The material is classified as

- B1 schwerentflammbare Stoffe
- B2 normalentflammbare Stoffe
- B3 leichtentflammbare Stoffe

The fabric is classified B2 if after the B2 test:
- The time to reach the marked point is minimum 20s.
- The paper doesn’t ignite.
- The droplets are burning for maximum 2s.

A fabric is classified B1 if after the fire shaft test:
- The residual length is minimum 150mm.
- The temperature of the smoke is maximum 200°C.

Das Material ist klassifiziert.

- B1 schwerenflammbare Stoffe
- B2 normalentflammbare Stoffe
- B3 leichtenflammbare Stoffe

Der Stoff ist als B2 klassifiziert nach dem B2 Test:
- Es vergehen minimum 20s bis der 'marked point' erreicht ist.
- Das Papier entzündet sich nicht
- Die Tröpfchen brennen maximal 2s.

Ein Stoff is B1 klassifiziert nach dem Brandschachttest:
- Die verbleibende Länge des Probestücks ist minimum 150mm.
- Die Rauchtemperatur ist maximum 200°C.

Testing lab

Bodycote Warrington Brandhaus
Industrieprk Hochst, c 369
D-65926 Frankfurt am Main
Contact person: Knut Bauer
Phone: 49 69 3 05 38 82
Fax: +49 63 3 05 1 70 71
Email: Knut.bauer@bodycote.com
Germany